Resetting and Coding ALC Modules, Diagnostyka programowanie BMW

[ Pobierz całość w formacie PDF ]
//-->Pre-LCI to LCI Xenon AHL Conversion: Resetting and Coding ALC ModulesAdaptive Light Control modules, also known as Stepper Motor Controllers (SMC), are coded tooperate specifically for the vehicle and side they are installed in. Thus, installing used ALCmodules could result in directional aiming in the opposite direction of steering travel than isexpected. Recoding them into their new position first requires that they be reset; otherwise,recoding them may have no effect.The procedures described herein were conducted with NCS Expert Tool version 4.0.1 runningunder Windows 7 x64. Vehicle was a 2008 335i Sport Sedan AT with FRM2 module standard,firmware version FRM2_E89.C09. The LSMC and RSMC modules coded had firmware versionSMCDS_LI.CO7 and SMCDS_RE.CO7 respectively.Resetting ALC (SMC) Modules1. Launch NCS Expert Tool, and from the menu bar chooseFile->Load Profilemenu……select the “Expertmode Profile” or “ExpertmodusExpertmodus (Werkseinstellung)”(depending on what “expert” profiles you have available or installed), then click onOK.These “expert” profiles shouldnothave the “FSW-/PSW-Manipulate with FSW_PSW.MAN”option enabled; if necessary, edit the profile to disable this option to prevent errors fromoccurring during the reset procedures (save the profile under a unique name).2. Click on theFG/ZCS/FAbutton (or press [F1])……then theZCS/FA f. ECUbutton ([F3]).3. Select the “E89” chassis, click onOK……select “CAS”, “FRM”, or “NFRM” ECU (it doesn’t matter which), thenOK.This preloads the VIN into NCS Expert Tool so it won’t need to be manually entered forfollow-on operations. NCS Expert is now ready to process ECUs.4. Click on theBackbutton ([F6])……thenProcess ECUbutton ([F3]). [ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • tejsza.htw.pl

    •